n*********2 发帖数: 357 | 1 发现车库门有一个问题了: 每次按按钮开门的时候,门总是只开一小点。 需要再按一
次按钮, 这时门会重新关上, 然后自动全部开启。
我调节了门的开启力度, 检查了 sensor, 这些都不起作用。
大家碰到过这种情况吗? 这个是什么东西出了问题? 谢谢! |
F***Q 发帖数: 6599 | 2
put it in the manual opening mode, open and close the door with your hands,
feel if there is any resistance along the track.
check your cables and springs as well.
【在 n*********2 的大作中提到】![](/moin_static193/solenoid/img/up.png) : 发现车库门有一个问题了: 每次按按钮开门的时候,门总是只开一小点。 需要再按一 : 次按钮, 这时门会重新关上, 然后自动全部开启。 : 我调节了门的开启力度, 检查了 sensor, 这些都不起作用。 : 大家碰到过这种情况吗? 这个是什么东西出了问题? 谢谢!
|
n*********2 发帖数: 357 | 3 谢谢回复。
我找机会试试。 (记得以前我试过手动模式,那时门移动很平稳, 没有抵触力。)
,
【在 F***Q 的大作中提到】![](/moin_static193/solenoid/img/up.png) : : put it in the manual opening mode, open and close the door with your hands, : feel if there is any resistance along the track. : check your cables and springs as well.
|
F***Q 发帖数: 6599 | 4
you should also test if your door is balanced.
pull it 3-5 ft above the ground, the door should hold its position if you
draw your hand. it should only slowly slide down when you pull it about 1ft
above the ground.
if it is not balanced, your should adjust the springs by loosening or
tightening a bolt behind.
【在 n*********2 的大作中提到】![](/moin_static193/solenoid/img/up.png) : 谢谢回复。 : 我找机会试试。 (记得以前我试过手动模式,那时门移动很平稳, 没有抵触力。) : : ,
|
n*********2 发帖数: 357 | 5 今天试了一下。 转换到手动模式下, 开关门没有阻力。 然后转换回自动模式后,毛
病马上消失。 开关门好几次都没有问题。
但是到了第二天, 毛病又回来了。 准备周末再仔细测试一下。
1ft
【在 F***Q 的大作中提到】![](/moin_static193/solenoid/img/up.png) : : you should also test if your door is balanced. : pull it 3-5 ft above the ground, the door should hold its position if you : draw your hand. it should only slowly slide down when you pull it about 1ft : above the ground. : if it is not balanced, your should adjust the springs by loosening or : tightening a bolt behind.
|
l****u 发帖数: 980 | 6 有没有换个remote control试试?怀疑control是不是有double click的问题。按一下
,连续送两遍信号,第一个刚开,第二个停住;再按一下,又是两个信号,第一个关,
第二个开。没遇到过,只是觉得每次好像按了两下,真好是这个结果。 |
t*****j 发帖数: 264 | 7 try lubricate the spring
【在 n*********2 的大作中提到】![](/moin_static193/solenoid/img/up.png) : 发现车库门有一个问题了: 每次按按钮开门的时候,门总是只开一小点。 需要再按一 : 次按钮, 这时门会重新关上, 然后自动全部开启。 : 我调节了门的开启力度, 检查了 sensor, 这些都不起作用。 : 大家碰到过这种情况吗? 这个是什么东西出了问题? 谢谢!
|