k***y
发帖数: 1645 | 1 GAS RANGE，电打火，5个灶眼有三个不能总自动打着，听见啪啪响可是火不着，另外两
个相对不常用的灶眼倒没问题。能看见主灶眼里面有电子打火的火花。炉子还满新的，
清洁什么的也是定时做，是什么问题呢？有经验的麻烦指教一下吧～～ |
p*****r
发帖数: 361 | 2 先用火柴凑合一下吧。
【在 k***y 的大作中提到】
: GAS RANGE，电打火，5个灶眼有三个不能总自动打着，听见啪啪响可是火不着，另外两
: 个相对不常用的灶眼倒没问题。能看见主灶眼里面有电子打火的火花。炉子还满新的，
: 清洁什么的也是定时做，是什么问题呢？有经验的麻烦指教一下吧～～
|
k***y
发帖数: 1645 | 3 很危险滴
【在 p*****r 的大作中提到】
: 先用火柴凑合一下吧。
|
l***r
发帖数: 736 | |
k***y
发帖数: 1645 | 5 看来是普遍问题啊，没人想修修？
【在 l***r 的大作中提到】
: 我用打火机，那种长柄的
|
s******t
发帖数: 12883 | 6 气不畅。
【在 k***y 的大作中提到】
: GAS RANGE，电打火，5个灶眼有三个不能总自动打着，听见啪啪响可是火不着，另外两
: 个相对不常用的灶眼倒没问题。能看见主灶眼里面有电子打火的火花。炉子还满新的，
: 清洁什么的也是定时做，是什么问题呢？有经验的麻烦指教一下吧～～
|
s******t
发帖数: 12883 | 7 怕危险的话，有个简单做法，就是那里噼里啪啦打不着火的时候，把本来放在
炉子上的平底锅猛然往上一提，火就着了。因为猛提一下，造成局部低压，
煤气会加速喷出，被火星点燃。
【在 k***y 的大作中提到】
: 很危险滴
|
s******t
发帖数: 12883 | |
k***y
发帖数: 1645 | |
B******1
发帖数: 9094 | 10 You hear clicking but there's no ignition.
First thing to do in this case are the following observation checks which do
not require any tools, instruments, or taking anything apart.
1.Check the spark color. A healthy ignition system will produce crisp blue
sparks. A weak ignition system, on the other hand, will produce light blue,
almost white sparks. The following two checks can be made by switching the
suspected burner with a known operating burner:
◦Ignite the burner with a match to verify proper gas supply and air
shutter adjustment. Make sure the flame is a clean blue flame, not yellow
and sooty.
◦The gap between the ignitor and the burner base is too large. It
should be about the thickness of two dimes.
◦Gookus is caked on the ignitor or burner base. Clean the burner caps,
heads, flame spreaders, ignitors...that whole area. HINT: do not use stuff
like Comet because you'll gunk everything up big time. Warm water and Basic-
H are a good choice.
These following two checks are done by physical inspection "under the hood":
◦Loose wiring connections at the ignitor, the grounding strap, or
spark module.
◦Broken or pinched ignitor wire between the burner and module.
2.Check the spark frequency. Say what? A healthy spark system will crank out
three to five sparks per second. If yours is a lot slower than this, then
the prime suspect is reverse polarity at the 120vac outlet the range is
plugged into. The picture below shows a 120vac outlet with the proper
polarity.
From the following website:
http://fixitnow.com/2004/09/appliance-repair-revelation_17.htm |
B******1
发帖数: 9094 | 11 This web link even has some photos of how to repair the stove one step at a
time:
http://www.familyhandyman.com/DIY-Projects/Home-Repair/Applianc |
w******x
发帖数: 2769 | 12 没有那么复杂，把出火那块东西拿到外面水泥地上磨一磨就可以了。我家以前的就是这
么弄好的 |
