y*********i 发帖数: 7 | 1 my system is redhat7.1 and i wanna make Frees/wan run on it.
my step:
1. put the FreeS/WAN tarfile under /usr/src and untar it here by the command
tar -xzf freeswan*.gz
2. Kernel configuration
1) make menuconfig
2) make dep; make clean
3) make bzImage
4) make install
5) make modules
6) make modules_install
7) lilo (ensure that the boot loader sees my changes)
and from step 2-3) i find errors. i did nothing more and just followed the
install introduction. and when i reboot | bz 发帖数: 1770 | 2 patching kernel is not that easy.
you can wait till sometime later this year for a kernel module, instead of
doing all these kinds of stuff with the kernel.
BTW, the your tunnelling server is Nortel with aggressive negotiation, then
you are almost out of luck with FreeSwan, coz they wont support it.
【在 y*********i 的大作中提到】 : my system is redhat7.1 and i wanna make Frees/wan run on it. : my step: : 1. put the FreeS/WAN tarfile under /usr/src and untar it here by the command : tar -xzf freeswan*.gz : 2. Kernel configuration : 1) make menuconfig : 2) make dep; make clean : 3) make bzImage : 4) make install : 5) make modules
| i**a 发帖数: 13 | 3 Do you have the correct kernel under /usr/src/linux?
BTW, are you sure Freeswan support 2.4.4 kernel?
I worked on it about 1.5 yrs ago.
Anyway, it needs to pache the kernel and recompile the kernel.
from 1 -3, this is to compile the kernel.
Are u sure u have right kernel and configured it correctly?
【在 y*********i 的大作中提到】 : my system is redhat7.1 and i wanna make Frees/wan run on it. : my step: : 1. put the FreeS/WAN tarfile under /usr/src and untar it here by the command : tar -xzf freeswan*.gz : 2. Kernel configuration : 1) make menuconfig : 2) make dep; make clean : 3) make bzImage : 4) make install : 5) make modules
|
|