o*********r
发帖数: 203 | 1 1. Meterials Needed (from HomeDepot)
(1) two 2" x 4" x 48" studs
(2) two 2" x 4" x 34" studs
(3) two 1" x 2" x 36.5" studs
(4) two 1" x 2" x 39.75" studs
(5) harware cloth 36" x 5'
Nails: 1"
Screws: 3", 2.5", and 1.5"
2. Tools Needed
3.1. Drill 3 holes at 4" on studs (1). Total: 12 holes
3.2. Put togther: 3" screws for the middle hole; 2.5" srcews for other two
holes. Repeat 3 more times.
3.3. Product after 3.2
3.4. Mount haredware cloth with 1" nails
3.5. Cut extra hardware cloth off
Product after 3.5
3.7. Put studs (3) and (4) with 1.5" screws. BE CAREFUL: studs may be
splitted
Final Product | c******n
发帖数: 4965 | 2 hehe, your design is not as good as mine,
i bend the wire cloth 90 degrees and then clamp it with two wood planks,
this way it does not slip out
【在 o*********r 的大作中提到】
: 1. Meterials Needed (from HomeDepot)
: (1) two 2" x 4" x 48" studs
: (2) two 2" x 4" x 34" studs
: (3) two 1" x 2" x 36.5" studs
: (4) two 1" x 2" x 39.75" studs
: (5) harware cloth 36" x 5'
: Nails: 1"
: Screws: 3", 2.5", and 1.5"
: 2. Tools Needed
: 3.1. Drill 3 holes at 4" on studs (1). Total: 12 holes
| f*******e
发帖数: 4531 | 3 It is better to wrap the hardware cloth around for added strength. Not sure
how long this one can last.
however, it is a good idea to make one side longer so that you can tilt the
sifter for easy operation.
Have fun :) |
|
