y****o
发帖数: 3575 | 1 有其他办法么？另外换那个pad容易么？除了几个螺丝，还有其他什么trick？ |
v*****u
发帖数: 1796 | 2 do you mean c-clamp? it's a must
【在 y****o 的大作中提到】
: 有其他办法么？另外换那个pad容易么？除了几个螺丝，还有其他什么trick？
|
y****o
发帖数: 3575 | 3 对，能用小锤敲敲么？不就是把那个活塞压进去么？
【在 v*****u 的大作中提到】
: do you mean c-clamp? it's a must
|
u****a
发帖数: 568 | 4 C-clamp is not a must. You can use a long screw driver to pry on the back of
the old brake pad to press the piston down (insert between the pad and the
caliper). I did it multiple time with no prolem. |
p****r
发帖数: 766 | |
E*****w
发帖数: 1822 | 6 没有就去买一个
工欲善其事，必先利其器
你敲敲试下。
【在 y****o 的大作中提到】
: 对，能用小锤敲敲么？不就是把那个活塞压进去么？
|
y****o
发帖数: 3575 | 7 谢谢，容易么？
of
the
【在 u****a 的大作中提到】
: C-clamp is not a must. You can use a long screw driver to pry on the back of
: the old brake pad to press the piston down (insert between the pad and the
: caliper). I did it multiple time with no prolem.
|
u****a
发帖数: 568 | 8 It was pretty easy.
【在 y****o 的大作中提到】
: 谢谢，容易么？
:
: of
: the
|
y****o
发帖数: 3575 | 9 Thank，will try 明天，不知道要是搞不定，能不能再开去修车的地方。
【在 u****a 的大作中提到】
: It was pretty easy.
|
u****a
发帖数: 568 | 10 You should have no problem. Just insert the tip of the long screw driver
between the back of the outer pad and the caliper and pry slowly. Make sure
that you open the brake fluid cap under the hood to let the brake fuild flow
before you pry.
If in the rare case that you 搞不定, you can always put the old pads and the
wheel backso you can drive the car.
【在 y****o 的大作中提到】
: Thank，will try 明天，不知道要是搞不定，能不能再开去修车的地方。
|
