G***G
发帖数: 16778 | 1 Yesterday when I changed my brake rotors, I experienced a strange thing.
The rotor was rusted and couldn't be removed even after I hammered it very
forcefully.
Fortunately, there were two small holes in the rotor. I used the two small
holes
and screwed into two bolts. Finally the rotor was removed.
But my new rotor doesn't contain the two small holes. If it gets stuck in
the future, how can I remove it.
Anyone knows the answer?
I don't want to use hammer because it is new rotor, which means I will use
it again. I don't want to use torch because it will damage the nug luts.
Please shows us your talented ideas about how to remove a stuck front brake
rotor. thanks. |
t**x
发帖数: 20965 | |
G***G
发帖数: 16778 | 3 试过了。没空间做这个动作。
锤子锤两下，也没什么反应。
【在 t**x 的大作中提到】
: 用大木头棍子从里往外敲,
: 狠狠地轮圆了
: 两下
|
g**********3
发帖数: 1384 | 4 big 锤子...
【在 G***G 的大作中提到】
: Yesterday when I changed my brake rotors, I experienced a strange thing.
: The rotor was rusted and couldn't be removed even after I hammered it very
: forcefully.
: Fortunately, there were two small holes in the rotor. I used the two small
: holes
: and screwed into two bolts. Finally the rotor was removed.
: But my new rotor doesn't contain the two small holes. If it gets stuck in
: the future, how can I remove it.
: Anyone knows the answer?
: I don't want to use hammer because it is new rotor, which means I will use
|
G***G
发帖数: 16778 | 5 没用。我昨天用的锤子已经很大了。差点把jack stands震倒。
【在 g**********3 的大作中提到】
: big 锤子...
|
h******u
发帖数: 389 | 6 到autozone的loan tool的地方去借puller |
k*********s
发帖数: 4474 | 7 OTC heavy duty rotors puller |
G***G
发帖数: 16778 | 8 thank you
【在 k*********s 的大作中提到】
: OTC heavy duty rotors puller
|
G***G
发帖数: 16778 | 9 thank you.
【在 h******u 的大作中提到】
: 到autozone的loan tool的地方去借puller
|
o***m
发帖数: 203 | 10 我的用brake bar的背面正面击rotor掉了点灰，几下就下来了，为啥你的那个那么紧呢
，喷wd40到bolt孔里。 |
t**x
发帖数: 20965 | 11 我用直径大概10厘米左右, 长4英尺
木头柱子
两下解决
: 试过了。没空间做这个动作。
: 锤子锤两下，也没什么反应。
【在 G***G 的大作中提到】
: thank you.
|
